Hall B7/B7.1 Rear Tower for 25mm Shocks

This rear shock tower enables you to run the truck front shocks (25mm bodies, 24mm shafts) on the rear of your B7 or B7.1. We have found this combination to greatly improve performance on carpet due to lower centre of mass, as well as the car seeming to have a more consistent and predictable feel.

25mm bodies - AS91953

24mm shaft - AS91642

This shock tower ONLY works with the parts above from Team Associated.

Directions - Do not run internal or external shock limiters and aim for approximately a 26mm stroke length. Ideally use the 24mm shafts, but we have used 23mm and left more thread exposed when we could not source the 24mm. Tune droop and uptravel with rod end length (start with 0). This version is intended for use without the dropper plates.